Mircom BPS-1100 Especificações descarregar pdf (Página 14)

Mechanical Installation and Dimensions

Main Chassis Installation

1. Install the main chassis in the BB-1024 backbox as shown in Figure 3 below, using the supplied hex-nuts.

2. Group the incoming wires through the top of the enclosure to prepare them for wiring the modules. Do not run

the wires in-between the modules since this could cause a short circuit.

3. Use a wire tie to group wires for easy identification and neatness.

4. Be sure to connect a solid earth ground (from building system ground / to a cold water pipe) to the chassis

earth ground mounting lug, and to connect the earth ground wire lugs from the main chassis to the ground

screw on the backbox.

Figure 3 Main Chassis Installation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 71 72

Sem comentários

Mircom BPS-1100 Especificações Página 14